PARS Makina Power And Rotary Systems

09/04/2016

18/02/2016

Overset Grid özelliğinin kullanıldığı DTMB 5415 analizi.

DescriptionMotion modeling has always been a complex topic in CFD simulation. NUMECA’s Fine/Marine has always been ahead of the game when it comes to virtual...

14/01/2016

Cape Cod Universitesine kurulan WESTT ürünleri. Turbo motor eğitimleri ve araştırmaları için üstün teknoloji içeren çözümler...

27/11/2015

55 metrelik bir yatın model havuz testi ve FineMarine ile yapılmış CFD analiz sonuçlarının karşılaştırılması

We carried out a direct comparission between the our CFD code FINE/Marine and a towing tank test in regular waves for a 55m motor yacht. The correlation was ...

21/10/2015

Pars Makina'nın Türkiye temsilciliğini yaptığı Price Induction'a ait WESTT SE(V) ya da gerçek turbofan motoru makina mühendisliği ve uçak motoru bölümlerinde hiçbir güvenlik sorunu olmadan eğitim amaçlı kullanılabilir. Daha ayrıntılı bilgi için http://www.parsmakina.com/product/westt-sev-full-engine-assembly-station/

The WESTT SE(V) assembly and disassembly station is based on the DGEN engine that can be fully assembled and disassembled. The station includes special tools...

15/10/2015

The WESTT CS-BV system is a virtual engine test bench where the DGEN turbofan engine is simulated by the SIMMOT-system.

It offers two different orientations and training applications. On one side, the reprogrammable FADEC and the failures simulation module allow for the study of the engine's control system and its modern all-electric concept. On the other side, the virtual bench provides a proficient thermodynamic and aerodynamic exploration of the simulated engine as well as the full 3D-visualization depending on the flying conditions. The WESTT CS-BV is thus particularly versatile and interactive.

The WESTT CS-BV system is a virtual engine test bench where the DGEN turbofan engine is simulated by the SIMMOT-system. It offers two different orientations ...

15/10/2015

Hexpress capability for meshing on Boeing 737. Since geometry has an axis of symmetry that lies on z axis, no need to meshing entire geometry.