Gulfside Armor Co.

08/30/2026

This customer was tired of paying thousands every few years just to watch his equipment fade and wear right back down within a couple seasons.

We coated this one in InduroPro instead. Same protection that’s been holding up on boats for years, now doing the same thing for heavy equipment like this gooseneck. No more repaint cycle, no more thousands lost to fading and corrosion, just a coating built to actually last.

If you’re stuck repainting equipment every few years, message us. We’ll show you a better way before you spend that money again.

08/27/2026

Big news from Gulfside Armor.

We started out protecting boats down here, bringing faded hulls back to life and stopping rust before it eats a boat alive. That part isn’t going anywhere, we’ll always do that.

But we found something bigger. The same coating that’s been saving boats down here works just as hard on heavy equipment, and it flat out works. Construction equipment, fleets, marine gear, ag equipment, anything getting cooked by this sun and chewed up by salt air, we can bring it back to life and protect it for years.

This is where we’re putting everything going forward and we could not be more proud of it. If your equipment is looking rough, message us. We’ll come show you in person what this stuff can do before you spend a dime. InduroPro

08/27/2026

08/27/2026

Coming soon..

08/27/2026

Little change of scenery today. Took an F350 and wrapped the whole thing in Yacht Armor as our PPF of choice, and she came out amazing.

Big thanks to our guy Tray Cherry for trusting us with it. This stuff isn’t your average protection film. Yacht Armor Clear Shield is built to stand up to the Gulf Coast, rock chips, road grime, salt, sun, all of it, while keeping that paint looking exactly like the day it rolled off the lot.

If you’ve got a truck, boat, or anything you want protected the right way, come see us. We’ll take care of you

08/20/2026

This Contender 39ST came all the way from Venice, Louisiana — 3 hours and 15 minutes of trailering, right past every detail shop in between, to have Gulfside Armor handle it.

Here’s what we did:
🔹 Full exterior wash + salt/iron decontamination
🔹 Gelcoat cleaned and prepped
🔹 System X G-MAX+ ceramic coating — our max tier
🔹 Yacht Armor PPF on the interior — 7-year coverage, 3-year full replacement
🔹 5-year ceramic warranty, CARFAX registered

We ran through just about every coating on the market before we landed on System X. It’s the only one that held up the way we demand, and we’re certified to apply it. That’s why it’s the only coating we back with a 5-year guarantee — and that warranty is backed by System X themselves. Paired with Yacht Armor film on the interior, this boat’s protected inside and out.

When a customer drives 3+ hours to trust you with a boat like this, we don’t take it lightly.

Auto & marine detailing • Paint & gelcoat correction • System X Ceramic • Yacht Armor PPF • 3M Certified vinyl • Non-skid & hullside restoration • Rust removal • Bottom treatment

Your car. Your boat. Our obsession. 💧
📲 Book now — DM us or call/text (228) 234-9147

08/07/2026

Gulfside Armor Co. is hiring.

We do PPF and ceramic coatings on some of the nicest boats on the Coast. Growing the crew and looking for the right people.

Installers — experience with PPF, wraps, tint, or detailing. I pay for skill.
Trainees — no experience needed, just show up and work. I’ll teach you the craft.
Sales — good with people, uncapped commission.

Climate-controlled shop, top materials, work we’re proud to put our name on. Building this into the go-to marine protection shop on the Gulf.

PM me if interested

Know someone? Tag them below. 👇

08/02/2026

brand new 33 invincible came through for the full treatment and she turned out clean

we went top to bottom on this one. interior piping done in system x gmax+ ceramic and the deck nonskid coated in gmax+ too so it stays grippy and wipes down easy

the hullsides got the two part treatment. top half in system x gmax for that deep wet gloss and slick finish. bottom half wrapped in yacht armor down at the waterline where she takes all the abuse. gloss up top, armor down low

transom in system x, bottom of the boat in system x, and even coated the mercury engines in system x. knocked out the garmin mfds in yacht armor so those screens stay scratch and glare free

did this one for a good buddy brian verdigates. appreciate you trusting us with her brother

INVINCIBLE BOATS | Mercury Marine | System X Ceramic Protection| Yacht Armor |

05/27/2026

A brand new Freeman Boatworks 28 is a serious investment. Blake Arata didnt cut corners protecting his.

We took her top to bottom. Nothing left exposed.

The hull and transom wrapped in Yacht Armor Clear Shield MPF so every scuff, dock rash, and bit of UV hits the film instead of the boat. That finish stays factory fresh for years.

Then every smooth surface got System X Ceramic Protection Ceramic Protection G Max. Garmins, motors, tunnel, rub rails, console, second station. All of it sealed so water beads off and grime wipes away clean.

And the parts that take the real abuse got Gtechniq. Nonskid, livewells, fish boxes, all the vinyl and plastics. Even the rough stuff stays easy.

Half measures don’t protect a boat like this. You go all in or you don’t bother. Blake went all in.

Freeman 28 | Full hull + transom Yacht Armor MPF

System X G Max on every smooth surface

Gtechniq on nonskid, livewells, fishboxes, vinyl and plastics

Orange Beach to Venice we got you

📲 Inquiries: (228) 234-9147

🌐 gulfsidearmorco.com

05/27/2026

New sites up gulfsidearmorco.com go check us out!

Gulfside Armor Co. – Premium Yacht Armor & Boat Protection on the Gulf Coast. Protect your vessel with advanced paint protection film, preserving its beauty and value against harsh marine environments. We are the Gulf Coast’s only certified Yacht Armor installer, offering unmatched quality and l...